Ford 2014 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 132)

E142658

3. Press and hold the function button you

want to program for two seconds, then

release. Repeat this step. Depending

on your brand of garage door opener,

you may need to repeat this sequence

a third time.

Erasing the Function Button Codes

Note: You cannot erase individual buttons.

E142660

1. Press and hold the outer two function

buttons simultaneously for

approximately 20 seconds until the

indicator lights above the buttons flash

rapidly.

2. When the indicator lights flash, release

the buttons. You have erased the codes

for all buttons.

Reprogramming a Single Button

To program a device to a previously trained

button, follow these steps:

1. Press and hold the desired button. Do

NOT release the button.

2. The indicator light will begin to flash

after 20 seconds. Without releasing the

button, follow Step 1 in the

Programming section.

For questions or comments, contact

HomeLink at www.homelink.com or

1-800-355-3515.

Programming to a Genie Intellicode 2

Garage Door Opener

Note: You must program the Genie

Intellicode 2 transmitter to operate it with

the garage door opener.

Note: To program HomeLink to the

transmitter, you must first put the

transmitter into programming mode.

BA

E142661

Red indicator lightA.

Green indicator lightB.

1. Press and hold one of the buttons on

the hand-held transmitter for 10

seconds. The indicator light will change

from green to red and green.

2. Press the same button twice to confirm

the change to programming mode. If

done properly the indicator light will

appear red.

3. Hold the transmitter within 1–3 inches

(2–8 centimeters) of the button on the

visor you want to program.

129

F150 (TF6) , enUSA

Universal Garage Door Opener (If Equipped)

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 471 472

Commentaires sur ces manuels

Pas de commentaire