For questions or comments, please contact HomeLink威 at
www.homelink.com or 1-800-355-3515.
Erasing the Function Button Codes
Note: You cannot erase individual
buttons.
1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
indicator lights above the buttons
flash rapidly.
2. When the indicator lights flash,
release the buttons. The codes for
all buttons are erased.
Reprogramming a single button
To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
For questions or comments, contact HomeLink威 at www.homelink.com or
1-800-355-3515.
Programming HomeLink姞 to a Genie Intellicode姞 2 garage door
opener
Note: The Genie Intellicode威 2 transmitter must already be programmed
to operate with the garage door opener.
Programing the transmitters
To program HomeLink威 to the transmitter you must first put the
transmitter into programming mode. To do this
172 Universal Garage Door Opener (If Equipped)
2013 Taurus
Owners Guide gf, 2nd Printing
USA (fus)
Commentaires sur ces manuels