Ford 2013 Taurus v.2 Manuel d'utilisateur télécharger pdf (Page 332)

on the Safety Compliance Certification Label (affixed to either the door

hinge pillar, door-latch post, or the door edge that meets the door-latch

post, next to the driver’s seating position), or Tire Label which is located

on the B-Pillar or the edge of the driver’s door. The cold inflation

pressure should never be set lower than the recommended pressure on

the Safety Compliance Certification Label or Tire Label.

When weather temperature changes occur, tire inflation pressures also

change. A 10°F (6°C) temperature drop can cause a corresponding drop

of 1 psi (7 kPa) in inflation pressure. Check your tire pressures

frequently and adjust them to the proper pressure which can be found

on the Safety Compliance Certification Label or Tire Label.

To check the pressure in your tire(s):

1. Make sure the tires are cool, meaning they are not hot from driving

even a mile.

If you are checking tire pressure when the tire is hot, (i.e. driven more

than 1 mile [1.6 kilometers]), never bleed or reduce air pressure. The

tires are hot from driving and it is normal for pressures to increase above

recommended cold pressures. A hot tire at or below recommended cold

inflation pressure could be significantly under-inflated.

Note: If you have to drive a distance to get air for your tire(s), check

and record the tire pressure first and add the appropriate air pressure

when you get to the pump. It is normal for tires to heat up and the air

pressure inside to go up as you drive.

2. Remove the cap from the valve on one tire, then firmly press the tire

gauge onto the valve and measure the pressure.

3. Add enough air to reach the recommended air pressure.

Note: If you overfill the tire, release air by pressing on the metal stem in

the center of the valve. Then recheck the pressure with your tire gauge.

4. Replace the valve cap.

5. Repeat this procedure for each tire, including the spare.

Note: Some spare tires operate at a higher inflation pressure than the

other tires. For T-type mini-spare tires (see the Dissimilar Spare Tire

and Wheel Assembly Information section for description): Store and

maintain at 60 psi (4.15 bar). For full-size and dissimilar spare tires (see

the Dissimilar Spare Tire and Wheel Assembly Information section

for description): Store and maintain at the higher of the front and rear

inflation pressure as shown on the Tire Label.

6. Visually inspect the tires to make sure there are no nails or other

objects embedded that could poke a hole in the tire and cause an air

leak.

332 Wheels and Tires

2013 Taurus

Owners Guide gf, 2nd Printing

USA (fus)

1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 540 541

Commentaires sur ces manuels

Pas de commentaire

Ford 2013 Taurus v.2 Manuel d'utilisateur Page 332

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2013 Taurus v.2