Ford 2013 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 237)

100

101

Checking and adding manual transmission fluid (if equipped)

1. Clean the filler plug. It is located

on the passenger side of the

transmission.

2. Remove the filler plug and inspect

the fluid level.

3. For vehicles equipped with a V6 engine, the correct manual

transmission fill level is at the lower edge of the filler hole. For vehicles

equipped with a V8 engine, the correct manual transmission fill level is

1/2 inch (1.3 cm) below the edge of the filler hole.

4. Add enough fluid through the filler opening to bring the fluid up to the

recommended levels.

5. Install and tighten the fill plug securely.

Use only fluid that meets Ford specifications. Refer to the technical

specifications chart in the Capacities and Specifications chapter.

BRAKE AND CLUTCH FLUID CHECK

Brake and clutch (if equipped) systems are supplied from the same

reservoir.

Fluid levels between the MIN and MAX lines are within the normal

operating range; there is no need to add fluid. If the fluid levels are

outside of the normal operating range, the performance of the system

could be compromised; seek service from your authorized dealer

immediately.

POWER STEERING FLUID CHECK

Your vehicle is equipped with an electric power steering (EPS) system.

There is no fluid reservoir to check or fill.

FUEL FILTER

Your vehicle is equipped with a lifetime fuel filter that is integrated with

the fuel tank. Regular maintenance or replacement is not needed.

For Shelby fuel filter requirements, see the Shelby GT500 Supplement.

Maintenance 237

2013 05+ Mustang (197)

Owners Guide gf, 1st Printing

USA (fus)

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 436 437

Commentaires sur ces manuels

Pas de commentaire

Ford 2013 Mustang v.1 Manuel d'utilisateur Page 237

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2013 Mustang v.1