Ford 2013 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 70)

4. After three seconds but within 10 seconds of turning the ignition off,

insert the second previously coded key into the ignition.

5. Turn the ignition from off to on. Keep the ignition on for at least three

seconds, but no more than 10 seconds.

6. Turn the ignition off and remove the second previously programmed

coded key from the ignition.

7. After three seconds but within 20 seconds of turning the ignition off

and removing the previously programmed coded key, insert the new

unprogrammed key into the ignition.

8. Turn the ignition from off to on. Keep the ignition on for at least six

seconds.

9. Remove the newly programmed coded key from the ignition.

The key will start the vehicle’s engine and will operate the remote entry

system (if the new key is an integrated keyhead transmitter) if it has

been successfully programmed. The theft indicator light will illuminate

for three seconds and then go out to indicate successful programming.

If the key was not successfully programmed, the theft indicator light may

flash on and off. Wait 20 seconds and repeat Steps 1 through 8. Take

your vehicle to your authorized dealer to have the new key programmed

if you are still unsuccessful.

Wait 20 seconds and then repeat this procedure from Step 1 to program

an additional key.

ANTI–THEFT ALARM (IF EQUIPPED)

The active anti-theft system is designed to warn you in the event of

unauthorized vehicle entry and is also designed to help prevent

unwanted towing of the vehicle.

You can choose what is monitored by arming the system in different

ways.

Partial Monitor Mode

To monitor the following:

• Doors

• Hood

• Trunk

Lock the vehicle using the key in the driver door key cylinder.

70 Security

2013 05+ Mustang (197)

Owners Guide gf, 1st Printing

USA (fus)

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 436 437

Pas de commentaire

Ford 2013 Mustang v.1 Manuel d'utilisateur Page 70