Ford 2013 Fusion v.3 Manuel d'utilisateur télécharger pdf (Page 260)

6. Remove the three front bumper cover

lower fasteners, only on the side of

headlamp being serviced.

E159697

7. Separate the front bumper cover from

the fender, pull the fender outward 3

cm.

E159698

8. From the front of the vehicle, pull the

front bumper cover forward 10 cm.

E159699

9. Carefully pull the headlamp assembly

outward to disengage it from the lower

fixing point.

10. Carefully lift the headlamp and

remove from vehicle.

11. Disconnect the electrical connector.

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to

accommodate normal changes in pressure.

Condensation can be a natural by-product

of this design. When moist air enters the

lamp assembly through the vents, there is

a possibility that condensation can occur

when the temperature is cold. When

normal condensation occurs, a thin film of

mist can form on the interior of the lens.

The thin mist eventually clears and exits

through the vents during normal operation.

Clearing time may take as long as 48 hours

under dry weather conditions.

Examples of acceptable condensation are:

• Presence of thin mist (no streaks, drip

marks or droplets).

• Fine mist covers less than 50% of the

lens.

Examples of unacceptable moisture

(usually caused by a lamp water leak) are:

• Water puddle inside the lamp.

• Large water droplets, drip marks or

streaks present on the interior of the

lens.

Take your vehicle to a dealer for service if

any of the above conditions of

unacceptable moisture are present.

257

Fusion/Mondeo (CC7)

Maintenance

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 457 458

Commentaires sur ces manuels

Pas de commentaire