Ford 2013 Fusion v.3 Manuel d'utilisateur télécharger pdf (Page 63)

You must have two previously

programmed coded keys and the new

unprogrammed key readily accessible. See

an authorized dealer to have the spare key

programmed if two previously

programmed coded keys are not available.

Read and understand the entire procedure

before you begin.

1. Insert the first previously programmed

coded key into the ignition.

2. Switch the ignition from off to on. Keep

the ignition on for at least three

seconds, but no more than 10 seconds.

3. Switch the ignition off and remove the

first coded key from the ignition.

4. After three seconds but within 10

seconds of switching the ignition off,

insert the second previously coded key

into the ignition.

5. Switch the ignition from off to on. Keep

the ignition on for at least three

seconds, but no more than 10 seconds.

6. Switch the ignition off and remove the

second previously programmed coded

key from the ignition.

7. After three seconds but within 10

seconds of switching the ignition off

and removing the previously

programmed coded key, insert the new

unprogrammed key into the ignition.

8. Switch the ignition from off to on. Keep

the ignition on for at least six seconds.

9. Remove the newly programmed coded

key from the ignition.

If the key has been successfully

programmed it will start the engine and

operate the remote entry system (if the

new key is an integrated keyhead

transmitter).

If it was not programmed successfully,

wait 10 seconds and repeat Steps 1 through

8. If you are still unsuccessful, take your

vehicle to an authorized dealer.

Programming a Spare Intelligent

Access Key

Note: You can program a maximum for four

intelligent access keys to your vehicle.

You must have two previously

programmed intelligent access keys inside

your vehicle and the new unprogrammed

intelligent access keys readily accessible.

See an authorized dealer to have the spare

key programmed if two previously

programmed keys are not available.

Make sure that the vehicle is off before

beginning this procedure. Make sure that

you close all the doors before beginning

and that they remain closed throughout

the procedure. Perform all steps within 30

seconds of starting the sequence. Stop

and wait for at least one minute before

starting again if you perform any steps out

of sequence.

Read and understand the entire procedure

before you begin.

E147165

1. Place a programmed intelligent access

key in the backup slot in the center

console. The key ring must be at the

top with the buttons facing toward the

rear.

2. Wait 5 seconds, then press the

START/STOP button.

3. Remove the intelligent access key.

60

Fusion/Mondeo (CC7)

Security

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 457 458

Commentaires sur ces manuels

Pas de commentaire