Ford 2013 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 140)

For questions or comments, contact

HomeLink at www.homelink.com or

1-800-355-3515.

Programming to a Genie Intellicode®

2 Garage Door Opener

Note: The Genie Intellicode 2 transmitter

must already be programmed to operate

with the garage door opener.

Note: To program HomeLink to the

transmitter you must first put the

transmitter into programming mode.

E142661

Red indicator lightA.

Green indicator lightB.

1. Press and hold one of the buttons on

the hand-held transmitter for 10

seconds. The indicator light will change

from green to red and green.

2. Press the same button twice to confirm

the change to programming mode. If

done properly the indicator light will

appear red.

3. Hold the transmitter within 1–3 inches

(2–8 centimeter) of the button on the

visor you want to program.

4. Press and hold both the programmed

Genie button on the hand-held

transmitter and the button you want

to program. The indicator light on the

visor will flash rapidly when the

programming is successful.

Note: The Genie transmitter will transmit

for up to 30 seconds. If HomeLink does not

program within 30 seconds the Genie

transmitter will need to be pressed again. If

the Genie transmitter indicator light displays

green and red, release the button until the

indicator light turns off before pressing the

button again.

Once HomeLink has been programmed

successfully, the Genie transmitter must

be changed out of program mode. To do

this:

1. Press and hold the previously

programmed Genie button on the

hand-held transmitter for 10 seconds.

The indicator light will change from red

to red and green.

2. Press the same button twice to confirm

the change. If done correctly the

indicator light will turn green.

Programming HomeLink to the Genie

Intellicode Garage Door Opener Motor

Note: You may need a ladder to access the

garage door opener motor.

E142662

1. Press and hold the program button on

the garage door opener motor until

both blue indicator lights turn on.

2. Release the program button. Only the

smaller round indicator light should be

on.

138

Universal Garage Door Opener

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 448 449

Commentaires sur ces manuels

Pas de commentaire