Ford 2009 Explorer v.1 Manuel d'utilisateur télécharger pdf (Page 120)

100

101

HomeLink威 should now activate your rolling code equipped device. To

program additional HomeLink威 buttons begin with Step 1 in this section.

For questions or comments, please contact HomeLink at

www.homelink.com or 1–800–355–3515.

Gate Operator & Canadian Programming

Console mount

Visor mount

During programming, your hand-held transmitter may automatically stop

transmitting — not allowing enough time for HomeLink威 to accept the

signal from the hand-held transmitter.

After completing Step 1 outlined in the Programming section, replace

Step 2 with the following:

Note: If programming a garage door opener or gate operator, it is

advised to unplug the device during the “cycling” process to prevent

overheating.

• Continue to press and hold the HomeLink威 button (note Step 2 in the

Programming section) while you press and release — every two

seconds (“cycle”) your hand-held transmitter until the frequency

signal has been accepted by the HomeLink威. The indicator light will

flash slowly and then rapidly after HomeLink威 accepts the radio

frequency signal.

• Proceed with Step 3 in the Programming section.

2009 Explorer (exp)

Owners Guide, 1st Printing

USA (fus)

Driver Controls

120

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 406 407

Commentaires sur ces manuels

Pas de commentaire

Ford 2009 Explorer v.1 Manuel d'utilisateur Page 120

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2009 Explorer v.1