Ford 2009 Edge v.2 Manuel d'utilisateur télécharger pdf (Page 64)

Replacing front parking lamp/turn signal bulbs

1. Make sure that the headlamp control is in the off position.

2. Open the hood.

3. Reach over the front bolster.

4. Rotate the bulb socket

counterclockwise and remove from

the lamp assembly.

5. Carefully pull the bulb out of the

socket and push in the new bulb.

6. Install the bulb socket into the

lamp assembly and rotate clockwise.

Replacing tail/stop/turn/sidemarker/backup lamp bulbs

The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same

portion of the tail lamp assembly, one just below the other. Follow the

same steps to replace either bulb:

1. Make sure the headlamp switch is

in the off position and then open

the liftgate to expose the lamp

assembly bolts.

2. Remove the two bolts from the

lamp assembly.

3. Carefully remove the lamp

assembly away from the vehicle by

pulling the assembly straight out to

expose the bulb socket. DO NOT

TIP THE LAMP ASSEMBLY SIDEWAYS.

4. Rotate the bulb socket counterclockwise and remove from lamp

assembly.

5. Pull bulb straight out of socket and snap in the new bulb.

2009 Edge (edg)

Owners Guide, 2nd Printing

USA (fus)

Lights

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 325 326

Pas de commentaire

Ford 2009 Edge v.2 Manuel d'utilisateur Page 64