Ford 2009 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 49)

1. With the flat side of the new bulb’s plastic base facing upward, insert

the glass end of the bulb into the lamp assembly. Turn the bulb left or

right to align the grooves in the plastic base with the tabs in the lamp

assembly. When the grooves are aligned, push the bulb into the lamp

assembly until the plastic base contacts the rear of the lamp assembly.

2. Install the bulb retaining ring over the plastic base until it contacts the

rear of the socket by rotating it clockwise until you feel a “stop.”

3. Connect the electrical connector into the rear of the plastic base until

it snaps, locking it into position.

4. Install the headlamp assembly with two retainers.

5. Install the radiator cover locking it in place with three knobs.

6. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking/turn signal lamp bulbs

To remove the front parking/turn signal lamp bulbs:

1. Make sure headlamp switch is in the off position, then open the hood.

2. Remove the radiator cover by turning the three knobs to the unlock

position.

3. Remove two retainers and pull

headlamp assembly forward to

expose bulb.

4. Remove the bulb socket by

rotating it counterclockwise, then

pulling it out of the lamp assembly.

5. Pull the bulb from the socket and

push in the new bulb.

6. Install the bulb socket into the

lamp assembly by rotating it

clockwise.

To complete installation, follow the

removal procedure in reverse order.

2009 Crown Victoria (cro)

Owners Guide, 2nd Printing

USA (fus)

Lights

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 270 271

Pas de commentaire

Ford 2009 Crown Victoria v.2 Manuel d'utilisateur Page 49