Ford 2008 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 161)

Note: Ensure the brake pedal is not

depressed during this sequence.

To reprogram the remote entry

transmitters:

1. Ensure the vehicle is electronically unlocked.

2. Put the key in the ignition.

3. Turn the key from the 1 (OFF/LOCK) position to 3 (ON).

4. Cycle eight times rapidly (within 10 seconds) between the 1

(OFF/LOCK) position and 3 (ON). Note: The eighth turn must end in

the 3 (ON) position.

5. The doors will lock, then unlock, to confirm that the programming

mode has been activated.

6. Within 20 seconds press any button on the remote entry transmitter.

Note: If more than 20 seconds have passed you will need to start the

procedure over again.

7. The doors will lock, then unlock, to confirm that this remote entry

transmitter has been programmed.

8. Repeat Step 6 to program each additional remote entry transmitter.

9. Turn the ignition to the 1 (OFF/LOCK) position after you have

finished programming all of the remote entry transmitters.

10. The doors will lock, then unlock, to confirm that the programming

mode has been exited.

Illuminated entry

The interior lamps illuminate when the remote entry system is used to

unlock the door(s) or sound the personal alarm.

The illuminated entry system will turn off the interior lights if:

• the ignition is turned to the 2 (ACC) or 3 (ON) position, or

• the remote transmitter lock control is pressed, or

• after 25 seconds of illumination.

The dome lamp control (if equipped) must not be set to the off position

for the illuminated entry system to operate.

2008 Explorer (exp)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

161

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 399 400

Pas de commentaire

Ford 2008 Explorer v.2 Manuel d'utilisateur Page 161