Ford 2008 Escape Hybrid v.1 Manuel d'utilisateur télécharger pdf (Page 90)

Switching from two step to one step door unlocking

Unlocking can be switched between two step and one step door

unlocking by pressing and holding both

and buttons

simultaneously on the remote entry transmitter for approximately

4 seconds. The turn signal will flash twice to indicate that the vehicle has

switched to one step unlocking. Repeat the procedure to switch back to

two step unlocking.

Locking the doors

1. Press and release to lock all the doors. Assuming all vehicle doors

and the liftgate are properly closed and the park/turn lamps will flash

once.

2. Press

and release again within three seconds to confirm that all

the doors and liftgate are closed and locked. Note: The doors will lock

again and the horn will chirp once.

If any of the doors or the hood are not properly closed, the horn will

chirp twice and park/turn lamps will not flash when the

control is

pressed.

Opening the liftgate (if equipped)

Press twice within 3 seconds to open the liftgate glass.

Car finder

Press

twice within 3 seconds. The horn will chirp and the turn lamps

will flash. It is recommended that this method be used to locate your

vehicle, rather than using the panic alarm.

Sounding a panic alarm

Press and hold

for 1.5 seconds to activate the alarm. To deactivate

the feature, press the control again, turn the ignition to the 3 (RUN) or

4 (START) position, or wait for the alarm to time out in approximately

3 minutes.

Note: The panic alarm will only operate when the ignition is in the 1

(LOCK) position.

Replacing the battery

The Integrated Keyhead Transmitter uses one coin type three-volt

lithium battery CR2032 or equivalent.

2008 Escape Hybrid (ehv)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 311 312

Pas de commentaire

Ford 2008 Escape Hybrid v.1 Manuel d'utilisateur Page 90