Ford 2007 Five Hundred v.2 Manuel d'utilisateur télécharger pdf (Page 79)

Note: There are 30 seconds in which to initiate Step 7.

7. Return to the vehicle and firmly press, hold for two seconds and

release the programmed HomeLink威 button. Repeat the

press/hold/release sequence again, and, depending on the brand of the

garage door opener (or other rolling code equipped device), repeat this

sequence a third time to complete the programming.

HomeLink威 should now activate your rolling code equipped device. To

program additional HomeLink威 buttons begin with Step 2 in the

“Programming” section. For questions or comments, please contact

HomeLink威 at www.homelink.com or 1–800–355–3515.

Gate Operator & Canadian Programming

During programming, your

hand-held transmitter may

automatically stop transmitting —

not allowing enough time for

HomeLink威 to accept the signal

from the hand-held transmitter.

After completing Steps 1 and 2

outlined in the “Programming”

section, replace Step 3 with the following:

Note: If programming a garage door opener or gate operator, it is

advised to unplug the device during the “cycling” process to prevent

overheating.

• Continue to press and hold the HomeLink威 button (note Step 3 in the

“Programming” section) while you press and release — every two

seconds (“cycle”) your hand-held transmitter until the frequency

signal has been accepted by the HomeLink威. The indicator light will

flash slowly and then rapidly after HomeLink威 accepts the radio

frequency signal.

• Proceed with Step 4 in the “Programming” section.

2007 Five Hundred (500)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 287 288

Pas de commentaire

Ford 2007 Five Hundred v.2 Manuel d'utilisateur Page 79