Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 66)

Bounce back override: To override bounce back, within 2 seconds after

reaching bounce back position, if the switch is held in the close position

the moon roof will close with a 20–25 percent increase of closing force

before it will bounce back again. If the switch is released before the

moon roof reaches fully closed position, the moon roof will stop. For

example: Bounce Back Override can be used to overcome the resistance

of ice on the moon roof or seals.

To vent:

• To tilt the moon roof into the vent position (when the glass panel is

closed), press and hold the front portion of the control.

• To close the moon roof from the vent position, press and hold the rear

portion of the control until the glass panel stops moving.

The moon roof has a sliding shade that can be opened or closed when

the glass panel is shut. To close the shade, pull it toward the front of the

vehicle.

Accessory delay:

With accessory delay, the window switches, audio system, and moon roof

(if equipped) may be used for up to 10 minutes after the ignition switch

is turned to the OFF position or until either front door is opened.

STANDARD MESSAGE CENTER (IF EQUIPPED)

With the ignition in the ON position,

the message center, located on your

instrument cluster, displays

important vehicle information

through a constant monitor of

vehicle systems. You may select

display features on the message center for a display of status. The

system will also notify you of potential vehicle problems with a display of

system warnings followed by an indicator chime.

Selectable features

Press and release the TRIP/RESET

control switch to scroll and reset

the following functions. Select or

reset the function by holding the

TRIP/RESET button for more that

2 seconds.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 66