Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 100)

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the battery

down to ensure that the battery is fully seated in the battery housing

cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

transmitters, you can either reprogram them yourself, or take all

remote entry transmitters to your authorized dealer for

reprogramming.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

100

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 100