Ford 2005 Freestar Manuel d'utilisateur Page 191

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 312
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 190
4. Check that the flat tire is properly secured.
Stowing the spare tire
1. Lay the spare, inflated tire on the ground with the valve stem facing
down.
2. Insert the primary wheel retainer through the center of the wheel.
3. Use the winch mechanism to pull, and raise the tire under the vehicle.
4. Wagon only: Raise the tire by turning the lug nut wrench clockwise
until the hex nut ratchets.
Cargo van only: Raise the tire by turning the jack extension tool
clockwise with the lug nut wrench until the hex nut ratchets.
The effort to turn the jack handle increases significantly and the spare
tire carrier ratchets or slips when the tire is raised to the maximum
tightness. Tighten to the best of your ability, to the point where the
ratchet/slip occurs, if possible. The spare tire carrier will not allow you to
overtighten. If the spare tire carrier ratchets or slips with little effort,
take the vehicle to your authorized dealer for assistance at your earliest
convenience.
5. Check that the tire lies flat against the frame and is properly
tightened. Try to push or pull, then turn the tire to be sure it will not
move. Loosen and retighten, if necessary. Failure to properly stow the
spare tire may result in failure of the winch cable and loss of the tire.
NOTE: Visually check to make sure the wheel plate is resting flat against
the tire.
6. Repeat this tightness check procedure when servicing the spare tire
pressure (every six months, per Scheduled Maintenance Guide), or at
any time that the spare tire is disturbed through service of other
components.
WHEEL LUG NUT TORQUE SPECIFICATIONS
Retighten the lug nuts to the specified torque at 500 miles (800 km)
after any wheel disturbance (rotation, flat tire, wheel removal, etc.).
Bolt size Wheel lug nut torque*
lb.ft. Nm
1
2
x 20 100 135
* Torque specifications are for nut and bolt threads free of dirt and
rust. Use only Ford recommended replacement fasteners.
2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA (fus)
Tires, Wheels and Loading
191
Vue de la page 190
1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 311 312

Commentaires sur ces manuels

Pas de commentaire

Furuno FELCOM 250 manuály

Uživatelské manuály a uživatelské příručky pro Hardware Furuno FELCOM 250.
Poskytujeme 1 manuály pdf Furuno FELCOM 250 ke stažení zdarma podle typů dokumentů: Uživatelský manuál


Furuno FELCOM 250 Uživatelský manuál (66 strany)


Značka: Furuno | Kategorie: Hardware | Velikost: 6.46 MB |

 

Tabulka s obsahem

Installation Manual

1

INMARSAT FLEETBROADBAND

1

FELCOM 250/FELCOM 500

1

A : AUG 2009

2

H : FEB . 18, 2011

2

Pub. No. IME-56660-H

2

(YOSH ) FELCOM500/250

2

SAFETY INSTRUCTIONS

3

SYSTEM CONFIGURATION

4

EQUIPMENT LISTS

5

1. HOW TO INSTALL THE UNIT

7

MICROWAVE RADIATION !

8

NO ADMITTANCE WITHIN 1.40 m

8

NO ADMITTANCE WITHIN 0.7 m

9

Pressure

10

(Above figure: FELCOM 500)

10

FELCOM 500

11

FELCOM 250

11

Procedure

12

1. HOW TO INSTALL THE UNIT

13

Name Type Code no. Qty

17

1.2 Communication Unit

18

1.3 IP Handset

19

(0.59")

20

90±0.5 (3.54")

20

120 (4.72")

20

132±0.5 (5.20")

21

144 (5.67")

21

127±1 (5.00")

21

Fixing plate (left)

22

Fixing plate (right)

22

Six places

22

Facsimile

22

How to change modem settings

23

Mounting location

23

How to mount

24

Remove plastic sheet and

25

2. CONNECTIONS

26

2.2 Antenna Cable

27

2. CONNECTIONS

28

12DSFA-CF as follows

29

2.3 Communication Unit

30

TTYCS-1 Cable fabrication

31

NMEA signal, External alarm

31

Cable fixture

32

Never connect as follows:

33

How to inset the grommet

34

Unit to affix

35

2.6 LAN Cable Fabrication

36

3. SETTING AFTER INSTALLATION

37

Administrator Login

38

Basic settings

39

Settings

39

3.2 GPS Setting

40

3.3 Analog Port Setting

41

Incoming Indicator

42

3.5 Serial Port Setting

43

3.6 Satellite Setting

44

3.7 OTA Setting

45

3.8 Handset Setting

46

Setting in the IP handset

47

APPENDIX 1 JIS CABLE GUIDE

50

㧼㧭㧯㧷㧵㧺㧳ޓ㧸㧵㧿㨀

51

+056#..#6+10/#6'4+#.5

52

Modular jack box

55

8/Mar/10 R.Esumi

57

11/Dec/09 R.Esumi

58

17/May/2010 TAKAHASHI

59

11/May/09 R.Esumi

61

18/Feb/09 R.Esumi

62

Y. Hatai

64

T.Matsuguchi

65

Y.NISHIYAMA

66





Další produkty a příručky pro Hardware Furuno

Modely Typ Dokumentu
ETR-30N Uživatelský manuál   Furuno ETR-30N User Manual, 48 stránky