Ford 2005 E-150 Manuel d'utilisateur télécharger pdf (Page 81)

4. Within 10 seconds of the light turning on, at a moderate speed, buckle

then unbuckle the safety belt.

• This will disable the BeltMinder娂 feature for that seating position if it

is currently enabled. As confirmation, the airbag warning light will

flash 4 times per second for 3 seconds.

• This will enable the BeltMinder娂 feature for that seating position if it

is currently disabled. As confirmation, the restraint system warning

light will flash 4 times per second for 3 seconds, followed by 3

seconds with the light off, then followed by the airbag warning light

flashing 4 times per second for 3 seconds again.

5. After receiving confirmation, the deactivation/activation procedure is

complete.

Safety belt extension assembly

If the safety belt is too short when fully extended, there isa8inch

(20 cm) safety belt extension assembly that can be added (part number

611C22). This assembly can be obtained from your dealer at no cost.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

Do not use extensions to change the fit of the shoulder belt

across the torso.

Safety belt maintenance

Inspect the safety belt systems periodically to make sure they work

properly and are not damaged. Inspect the safety belts to make sure

there are no nicks, tears or cuts. Replace if necessary. All safety belt

assemblies, including retractors, buckles, front safety belt buckle

assemblies, buckle support assemblies (slide bar-if equipped), shoulder

belt height adjusters (if equipped), shoulder belt guide on seatback (if

equipped), child safety seat LATCH and tether anchors, and attaching

hardware, should be inspected after a collision. Ford Motor Company

recommends that all safety belt assemblies in use in vehicles involved in

a collision be replaced. However, if the collision was minor and a

qualified technician finds that the belts do not show damage and

continue to operate properly, they do not need to be replaced. Safety

belt assemblies not in use during a collision should also be inspected and

replaced if either damage or improper operation is noted.

2005 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 247 248

Pas de commentaire

Ford 2005 E-150 Manuel d'utilisateur Page 81