Ford 2005 E-150 Manuel d'utilisateur télécharger pdf (Page 203)

• Do not overfill the engine

with oil. Oil levels above this

mark may cause engine

damage. If the engine is

overfilled, some oil must be

removed from the engine by a

qualified service technician.

7. Put the indicator back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

normal operating range on the engine oil level indicator (dipstick).

4. Install the indicator and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

1/4 of a turn until three clicks are heard or until the cap is fully seated.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level indicator and/or the engine oil filler cap removed.

Engine oil and filter recommendations

Look for this certification

trademark.

Use SAE 5W-20 engine oil.

Only use oils “Certified For Gasoline Engines” by the American

Petroleum Institute (API). An oil with this trademark symbol conforms

to the current engine and emission system protection standards and fuel

2005 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

203

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 247 248

Pas de commentaire

Ford 2005 E-150 Manuel d'utilisateur Page 203