Ford 2002 Explorer Manuel d'utilisateur télécharger pdf (Page 297)

VERTICAL AIM ADJUSTMENT

1. Park the vehicle on a level surface approximately 7.6 meters (25 feet)

from a vertical wall or screen directly in front of it.

• (1) Eight feet

• (2) Center height of lamp to ground

• (3) Twenty-five feet

• (4) Horizontal reference line

2. Measure the height from the

center of your headlamp to the

ground and mark a 2.4 meter (8

foot) horizontal reference line on

the vertical wall or screen at this

height (a piece of masking tape

works well). The center of the lamp

is marked by a 3.0 mm circle on the

headlamp lens.

3. Turn on the low beam headlamps to illuminate the wall or screen and

open the hood.

4. On the wall or screen you will

observe a light pattern with a

distinct horizontal edge of high

intensity light with a slight angle

towards the right. If this edge is not

at the horizontal reference line, the

beam will need to be adjusted.

5. Locate the vertical adjuster on

each headlamp, then usea4mm

socket/wrench to turn the adjuster

either counterclockwise (to adjust

down) or clockwise (to adjust up)

aligning the upper edge of the light

pattern up to the horizontal line.

6. HORIZONTAL AIM IS NOT

REQUIRED FOR THIS VEHICLE

AND IS NON-ADJUSTABLE.

7. Close the hood and turn off the lamps.

Maintenance and care

297

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 335 336

Pas de commentaire

Ford 2002 Explorer Manuel d'utilisateur Page 297