Ford 2002 Explorer Manuel d'utilisateur télécharger pdf (Page 104)

Do not use the HomeLinkt Universal Transceiver with any garage door

opener that lacks safety stop and reverse features as required by U.S.

federal safety standards (this includes any garage door opener model

manufactured before April 1, 1982). A garage door which cannot detect

an object, signaling the door to stop and reverse, does not meet current

U.S. federal safety standards. For more information, contact HomeLinkt

at: www.homelink.com or 1–800–355–3515.

Retain the original transmitter for use in other vehicles as well as for

future programming procedures (i.e. new HomeLinkt equipped vehicle

purchase). It is also suggested that upon the sale of the vehicle, the

programmed Homelinkt Universal Transceiver buttons be erased for

security purposes, refer to Programming in this section.

Programming

Do not program the HomeLinkt Universal Transceiver with the

vehicle parked in the garage.

Note: Some vehicles may require the ignition switch to be turned to the

second (or “ACC”) position for programming and/or operation of the

HomeLinkt. It is also recommended that a new battery be placed in the

hand-held transmitter of the device being programmed to HomeLinkt for

quicker training and accurate transmission of the radio-frequency signal.

1. Press and hold the two outside

buttons releasing only when the red

light begins to flash after 20

seconds. Do not repeat step one to

program additional hand-held

transmitters to the remaining two

HomeLinkt buttons. This will erase

previously programmed hand-held

transmitter signals into HomeLinkt.

2. Position the end of your

hand-held transmitter 2–8 cm (1–3 inches) away from the HomeLinkt

Universal Transceiver surface (located on your overhead console) while

keeping the red light in view.

Controls and features

104

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 335 336

Pas de commentaire

Ford 2002 Explorer Manuel d'utilisateur Page 104