Ford 2002 Explorer Manuel d'utilisateur télécharger pdf (Page 294)

100

101

Replacing tail/brake/turn/backup lamp bulbs

The tail/brake/turn/backup bulbs are located in the tail lamp assembly,

one just below the other. Follow the same steps to replace either bulb:

1. Make sure headlamp switch is in

OFF position, then open the liftgate

to expose the lamp assembly

screws.

2. Remove the two screws from the

lamp assembly.

3. Pull the lamp assembly towards

the rear and side of the vehicle at

an angle carefully removing it from

the vehicle.

4. Rotate the bulb socket counterclockwise and remove from lamp

assembly.

5. Pull the bulb straight out of the socket and push in the new bulb.

6. To complete installation, follow the removal procedure in reverse

order.

Replacing foglamp bulbs

1. Make sure headlamp switch is in

OFF position, then reach under the

front bumper and remove the bulb

socket from the foglamp by turning

counterclockwise.

2. Disconnect the electrical

connector from the foglamp bulb.

3. Connect the electrical connector

to the new foglamp bulb.

4. Install the bulb socket in the foglamp turning clockwise.

Maintenance and care

294

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 335 336

Commentaires sur ces manuels

Pas de commentaire

Ford 2002 Explorer Manuel d'utilisateur Page 294

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2002 Explorer