Ford 2002 Explorer Manuel d'utilisateur télécharger pdf (Page 134)

1. Insert the first previously

programmed coded key into the

ignition and turn the ignition from 2

(ACC) to 3 (ON) (maintain ignition

in 3 (ON) for at least one second).

2. Turn ignition to 1 (LOCK) and

remove the first coded key from

the ignition.

3. Within ten seconds of turning the

ignition to 2 (ACC), insert the

second previously programmed coded key into the ignition and turn the

ignition from 2 (ACC) to 3 (ON) (maintain ignition in 3 (ON) for at least

one second but no more than ten seconds).

4. Turn the ignition to 1 (LOCK) and remove the second coded key

from the ignition.

5. Within 20 seconds of turning the ignition to 2 (ACC), insert the new

unprogrammed key (new key/valet key) into the ignition and turn the

ignition from 2 (ACC) to 3 (ON) (maintain ignition in 3 (ON) for at least

one second). This step will program your new key to a coded key.

6. To program additional new unprogrammed key(s), repeat this

procedure from step 1.

If successful, the new coded key(s) will start the vehicle’s engine and the

theft indicator will illuminate for three seconds and then go out.

If not successful, the new coded key(s) will not start the vehicle’s engine

and the theft indicator will flash on and off and you may repeat steps 1

through 6. If failure repeats, bring your vehicle to your dealership to

have the new spare key(s) programmed.

Controls and features

134

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 335 336

Pas de commentaire

Ford 2002 Explorer Manuel d'utilisateur Page 134