Ford 1998 Ranger Manuel d'utilisateur télécharger pdf (Page 46)

Conditions of operation

If... Then...

The driver’s safety belt is not

buckled before the ignition switch

is turned to the ON position...

The safety belt warning light

illuminates for one to two minutes

and the warning chime sounds for

four to eight seconds.

The driver’s safety belt is buckled

while the indicator light is

illuminated and the warning chime

is sounding...

The safety belt warning light and

warning chime turn off.

The driver’s safety belt is buckled

before the ignition switch is turned

to the ON position...

The safety belt warning light and

indicator chime remain off.

Safety belt maintenance

Check the safety belt systems periodically to make sure they work

properly and are not damaged. Check the safety belts to make sure there

are no nicks, wears or cuts. All safety belt assemblies, including

retractors, buckles, front seat belt buckle assemblies (slide bar)

(if equipped), shoulder belt height adjusters (if equipped), child safety

seat tether bracket assemblies (if equipped), and attaching hardware,

should be inspected after a collision. Ford recommends that all safety

belt assemblies used in vehicles involved in a collision be replaced.

However, if the collision was minor and a qualified technician finds that

the belts do not show damage and continue to operate properly, they do

not need to be replaced. Safety belt assemblies not in use during a

collision should also be inspected and replaced if either damage or

improper operation is noted.

Failure to replace the safety belt assembly under the above

conditions could result in severe personal injuries in the event of

a collision.

Refer to Cleaning and maintaining the safety belts in the

Maintenance and care section.

Seating and safety restraints

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 159 160

Pas de commentaire

Ford 1998 Ranger Manuel d'utilisateur Page 46