Ford 1998 Crown Victoria Manuel d'utilisateur télécharger pdf (Page 55)

3. Within five seconds of turning the ignition to OFF, insert the second

previously programmed SecuriLocky key into the ignition and turn the

ignition from OFF to RUN (maintain ignition in RUN for at least one

second but no more than 5 seconds).

4. Turn the ignition to OFF and remove the second SecuriLocky key

from the ignition.

5. Within 10 seconds of turning the ignition to OFF, insert the

unprogrammed SecuriLocky key (new key) into the ignition and turn

the ignition from OFF to RUN (maintain ignition in RUN for at least one

second). This step will program your new SecuriLocky key.

6. To program additional SecuriLocky key(s), repeat this procedure from

step 1.

If the programming procedure was successful, the new SecuriLocky

key(s) will start the vehicle’s engine. The theft indicator (located on the

instrument panel) will light for three seconds and then go out.

If the programming procedure was not successful, the new SecuriLocky

key(s) will not operate the vehicle’s engine. The theft indicator will flash

on and off. Wait at least one minute and then repeat the procedure from

step 1. If failure repeats, bring your vehicle to your dealership to have

the spare SecuriLocky key(s) programmed.

KEYLESS ENTRY SYSTEM

With the keyless entry keypad, you

can:

• lock or unlock the vehicle doors

without using the key

• open trunk

• disable/enable horn chirp

• disable/enable autolock

See also Remote entry system in this chapter for more information.

Your vehicle has a factory-set 5–digit code that operates the keyless

entry system. You can also program your own 5–digit personal entry

code.

1 2

45678

Controls and features

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 159 160

Pas de commentaire

Ford 1998 Crown Victoria Manuel d'utilisateur Page 55