Ford 1998 Crown Victoria Manuel d'utilisateur télécharger pdf (Page 103)

Reinstalling the anti-theft lug nut

1. Insert the key over the locking lug nut.

2. Place the lug nut wrench over the lug nut key and apply pressure on

the key with the wrench.

3. Install the lug nut.

Tire change procedure

To prevent the vehicle from moving when you change a tire, be

sure the parking brake is set, then block (in both directions) the

wheel that is diagonally opposite (other side and end of the vehicle) to

the tire being changed.

If the vehicle slips off the jack, you or someone else could be

seriously injured.

1. Park on a level surface, activate hazard flashers and set parking brake.

2. Place gearshift lever in P (Park).

3. Remove the spare tire, jack and

lug wrench.

4. Locate pry off notch (if

equipped) and remove the center

ornament from the aluminum wheel

with the tapered end of the wheel

nut wrench that came with your

vehicle. Insert and twist the handle,

then pry against the wheel.

5. Loosen each wheel lug nut

one-half turn counterclockwise but

do not remove them until the wheel

is raised off the ground. Refer to

Anti-theft lug nuts for information

on removing anti-theft lug nuts.

Roadside emergencies

103

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 159 160

Pas de commentaire

Ford 1998 Crown Victoria Manuel d'utilisateur Page 103