Ford 2011 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 232)

• If the oil level is below the lower hole or the MIN mark, add enough

oil to raise the level between the two holes or between the MIN-MAX

range.

• Oil levels above the upper hole or MAX mark may cause engine

damage. Some oil must be removed from the engine by an authorized

dealer.

7. Put the dipstick back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is within the

normal range on the engine oil level dipstick.

4. Install the dipstick and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap 1/4 turn

until it stops.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level dipstick and/or the engine oil filler cap removed.

Engine oil recommendations

2.3L engine

Look for this certification

trademark.

Maintenance and Specifications

232

2011 Ranger (ran)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 227 228 229 230 231 232 233 234 235 236 237 ... 302 303

Pas de commentaire

Ford 2011 Ranger v.2 Manuel d'utilisateur Page 232