Ford 2008 Focus v.3 Manuel d'utilisateur télécharger pdf (Page 89)

Safety belts with locking cinch tongue (rear center position only)

The locking cinch tongue will slide up and down the belt webbing when

the belt is in the stowed position or while putting safety belts on. When

the locking cinch tongue of the lap/shoulder combination safety belt is

latched into the buckle, the cinch tongue will allow the lap portion to

become shorter, but locks the webbing in place to restrict it from

becoming longer.

Before you can reach and latch a combination lap and shoulder belt

having a cinch tongue into the buckle, you may have to lengthen the lap

belt portion of it.

1. To lengthen the lap belt, pull

some webbing out of the shoulder

belt retractor.

2. While holding the webbing below

the tongue, grasp the tip (metal

portion) of the tongue so that it is

parallel to the webbing and slide the

tongue upward.

3. Provide enough lap belt length so that the tongue can reach the

buckle.

How to fasten the cinch tongue

1. Pull the combination lap and shoulder belt from the retractor so that

the shoulder belt portion of the safety belt crosses your shoulder and

chest.

2. Be sure the belt is not twisted. If the belt is twisted, remove the twist.

3. Insert the belt tongue into the proper buckle for your seating position

until you hear a snap and feel it latch.

4. Make sure the tongue is securely fastened to the buckle by pulling on

the tongue.

WARNING: The lap belt should fit snugly and as low as possible

around the hips, not across the waist.

WARNING: Front and rear seat occupants, including pregnant

women, should wear safety belts for optimum protection in an

accident.

2008 Focus (foc)

Owners Guide

USA (fus)

Seating and Safety Restraints

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 257 258

Pas de commentaire

Ford 2008 Focus v.3 Manuel d'utilisateur Page 89