Ford 2008 Focus v.3 Manuel d'utilisateur télécharger pdf (Page 122)

5. While pushing down with your

knee on the child seat pull up on

the shoulder belt portion to tighten

the lap belt portion of the

combination lap and shoulder belt.

6. Allow the safety belt to retract and remove any slack in the belt to

securely tighten the child safety seat in the vehicle.

7. Before placing the child into the

child seat, forcibly pull the child

seat forward and back to make sure

that the seat is held securely in

place. To check this, grab the seat

at the belt path and attempt to

move it side to side and forward and

back. There should be no more than

one inch of movement for proper

installation.

8. Check from time to time to be sure that there is no slack in the

lap/shoulder belt. The shoulder belt must be snug to keep the lap belt

tight during a collision.

Attaching child safety seats with tether straps

Most new forward-facing child safety seats include a tether strap which

goes over the back of the seat and hooks to an anchoring point. Tether

straps are available as an accessory for many older safety seats. Contact

the manufacturer of your child seat for information about ordering a

tether strap.

The rear seats of your vehicle are equipped with built-in tether strap

anchors located behind the seats as described below.

The tether anchors in your vehicle are either located under a cover

marked with the tether anchor symbol (shown with title) or are recessed

bars on the back side of the seatback.

2008 Focus (foc)

Owners Guide

USA (fus)

Seating and Safety Restraints

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 257 258

Pas de commentaire

Ford 2008 Focus v.3 Manuel d'utilisateur Page 122