Ford 2008 Focus v.3 Manuel d'utilisateur télécharger pdf (Page 240)

for 15 seconds without cranking the engine. If the Service engine

soon

indicator blinks eight times, it means that the vehicle is not

ready for I/M testing; if the Service engine soon indicator stays on

solid, it means that the vehicle is ready for I/M testing.

The OBD-II system is designed to check the emission control system

during normal driving. A complete check may take several days. If the

vehicle is not ready for I/M testing, the following driving cycle consisting

of mixed city and highway driving may be performed:

15 minutes of steady driving on an expressway/highway followed by

20 minutes of stop-and-go driving with at least four 30-second idle

periods.

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete. If

the vehicle is still not ready for I/M testing, the above driving cycle will

have to be repeated.

POWER STEERING FLUID

Check the fluid. Refer to the

scheduled maintenance

information for service

maintenance schedules.

1. Start the engine and let it run

until it reaches normal operating

temperature.

2. Turn the steering wheel left and

right several times.

3. Turn the engine off.

4. Check the fluid level.

5. If the fluid is below the MIN line, add fluid in small amounts until it

reaches the correct level (between the MIN and MAX lines). Refer to

Maintenance product specifications and capacities in this chapter for

the proper fluid type.

2008 Focus (foc)

Owners Guide

USA (fus)

Maintenance and Specifications

240

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 257 258

Pas de commentaire

Ford 2008 Focus v.3 Manuel d'utilisateur Page 240