Ford 2008 F-550 v.3 Manuel d'utilisateur télécharger pdf (Page 318)

Inspect the wheel pilot hole prior to

installation. If there is visible

corrosion in wheel pilot hole,

remove loose particles by wiping

with clean rag and apply grease.

Apply grease only to the wheel pilot

hole surface by smearing a “dime”

(1 square cm) sized glob of grease

around the wheel pilot surface (1)

with end of finger. DO NOT apply

grease to lug nut/stud holes or

wheel-to-brake surfaces.

JUMP STARTING YOUR VEHICLE

The gases around the battery can explode if exposed to flames,

sparks, or lit cigarettes. An explosion could result in injury or

vehicle damage.

Batteries contain sulfuric acid which can burn skin, eyes and

clothing, if contacted.

Do not attempt to push-start your automatic transmission

vehicle. Automatic transmissions do not have push-start

capability. Attempting to push-start a vehicle with an automatic

transmission may cause transmission damage.

Preparing your vehicle

When the battery is disconnected or a new battery is installed, the

transmission must relearn its shift strategy. As a result, the transmission

may have firm and/or soft shifts. This operation is considered normal and

will not affect function or durability of the transmission. Over time, the

adaptive learning process will fully update transmission operation.

1. Use only a 12–volt supply to start your vehicle.

2. Do not disconnect the battery of the disabled vehicle as this could

damage the vehicle’s electrical system.

3. Park the booster vehicle close to the hood of the disabled vehicle

making sure the two vehicles do not touch. Set the parking brake on

both vehicles and stay clear of the engine cooling fan and other moving

parts.

2008 F-250/350/450/550 (f23)

Owners Guide (post-2002-fmt)

USA (fus)

Roadside Emergencies

318

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 391 392

Pas de commentaire

Ford 2008 F-550 v.3 Manuel d'utilisateur Page 318