Ford 2002 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 200)

Removing snowplow

Read the following instructions before removing a snowplow:

• After removing a snowplow from the vehicle, ensure the vehicle’s front

toe alignment and front ride height are within specification (reset if

required). These specifications are located in the vehicle’s Workshop

Manual. Adherence to the toe and ride height specification is

important for proper tire wear, ride, handling and headlight aim.

Snowplowing with your air bag equipped vehicle

Your vehicle is equipped with driver

and passenger air bag Supplemental

Restraint System (SRS). The SRS is

designed to activate when the

vehicle sustains sufficient

longitudinal deceleration.

Careless or high speed driving while plowing snow which results in

sufficient vehicle decelerations can deploy the air bag. Such driving also

increases the risk of accidents.

All occupants of the vehicle, including the driver, should always

properly wear their safety belts, even when an air bag SRS is

provided.

Never remove or defeat the “tripping mechanisms” designed into the

snow removal equipment by its manufacturer. Doing so may cause

damage to the vehicle and the snow removal equipment as well as

possible air bag deployment.

Additional equipment such as snowplow equipment may effect

the performance of the air bag sensors increasing the risk of

injury. Please refer to the Body Builders Layout Book for instructions

about the appropriate installation of additional equipment.

Do not attempt to service, repair, or modify the Air Bag

Supplemental Restraint System or its fuses. See your Ford or

Lincoln Mercury dealer.

Driving

200

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 319 320

Pas de commentaire

Ford 2002 F-550 v.1 Manuel d'utilisateur Page 200