Ford 2001 Escape Manuel d'utilisateur télécharger pdf (Page 237)

7. Insert the glass end of the new bulb into the headlamp assembly.

When the bulb’s three metal tabs are aligned with the grooves in the

plastic base, push the bulb into the lamp assembly until the bulb’s metal

base contacts the plastic base.

8. Rotate the retainer spring over the bulb metal base and secure it on

the bulb hooks.

9. Install rubber boot on the lamp assembly. Be sure to press firmly

around the perimeter of the boot and around the bulb to ensure the

proper seal of the bulb.

10. Connect the electrical connector into the rear of the bulb until it

“snaps.”

Replacing brake/tail/turn/backup/rear fog lamp bulbs

The brake/tail/turn/backup/rear fog lamp bulbs are located in the tail

lamp assembly, one just below the other. Follow the same steps to

replace either bulb:

1. Open the liftgate to expose the

lamp assemblies.

2. Remove the two screws from the

lamp assembly.

3. Carefully remove the lamp

assembly by pulling it rearward to

disengage snap features on the

outward side of the lamp.

4. Twist the bulb socket

counterclockwise and remove from

lamp assembly.

Maintenance and care

237

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 279 280

Pas de commentaire

Ford 2001 Escape Manuel d'utilisateur Page 237