Ford 2001 Escape Manuel d'utilisateur télécharger pdf (Page 208)

6. Install a new air filter element. Be

careful not to crimp the filter

element edges between the air filter

housing and cover. This could cause

filter damage and allow unfiltered

air to enter the engine if not

properly seated.

7. Replace the air filter housing cover and secure the clamps.

8. Replace the air inlet tube and secure the clamp.

Note: Failure to use the correct air filter element may result in severe

engine damage. The customer warranty may be voided for any damage to

the engine if the correct air filter element is not used.

ENGINE COOLANT

Checking engine coolant

The concentration and level of engine coolant should be checked at the

mileage intervals listed in the scheduled maintenance guide. The coolant

concentration should be maintained at 50/50 coolant and water, which

equates to a freeze point of -36° C (-34° F). Coolant concentration

testing is possible with a hydrometer or antifreeze tester (such as the

Rotunda Battery and Antifreeze Tester, 014–R1060). The level of coolant

should be maintained at the “cold full” of “cold fill range” level in the

coolant reservoir. If the level falls below, add coolant per the instructions

in the Adding Engine Coolant section.

Your vehicle was factory-filled with a 50/50 engine coolant and water

concentration. If the concentration of coolant falls below 40% or above

60%, the engine parts could become damaged or not work properly. A

50–50 mixture of coolant and water provides the following:

• Freeze protection down to -36° C (-34° F).

• Boiling protection up to 129° C (265° F).

• Protection against rust and other forms of corrosion.

• Enables calibrated gauges to work properly.

Maintenance and care

208

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 279 280

Pas de commentaire

Ford 2001 Escape Manuel d'utilisateur Page 208