Ford 2013 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 191)

4. Locate the vertical adjuster on

each headlamp. Using a Phillips #2

screwdriver or a 13 millimeter

socket on a wrench, turn the

adjuster either clockwise or

counterclockwise in order to adjust

the vertical aim of the headlamp.

The horizontal edge of the brighter

light should touch the horizontal

reference line.

5. Close the hood and turn off the lamps.

HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS

NOT ADJUSTABLE.

CHANGING A BULB

Lamp Assembly Condensation

Exterior lamps are vented to accommodate normal changes in pressure.

Condensation can be a natural by-product of this design. When moist air

enters the lamp assembly through the vents, there is a possibility that

condensation can occur when the temperature is cold. When normal

condensation occurs, a thin film of mist can form on the interior of the

lens. The thin mist eventually clears and exits through the vents during

normal operation. Clearing time may take as long as 48 hours under dry

weather conditions.

These are examples of acceptable condensation:

• Presence of thin mist (no streaks, drip marks or droplets).

• Fine mist covers less than 50% of the lens.

These are examples of unacceptable moisture (usually caused by a lamp

water leak):

• Water puddle inside the lamp.

• Large water droplets, drip marks or streaks present on the interior of

the lens.

Take your vehicle to a dealer for service if any of the above conditions of

unacceptable moisture are present.

190 Maintenance

2013 Transit Connect (tst)

Owners Guide gf, 2nd Printing, November 2012

USA (fus)

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 320 321

Pas de commentaire

Ford 2013 Transit Connect v.2 Manuel d'utilisateur Page 191