Ford 2013 Fusion Hybrid v.1 Manuel d'utilisateur télécharger pdf (Page 174)

Different sequences of the light ring will

represent the status of the charge.

You can use your keyfob to view the

vehicles charge status at any time by

pressing the unlock button. The light ring

will light up the corresponding quadrant(s)

so that the current state of the vehicles

charge can be determined. If the charge is

below 25 percent the light ring will not

illuminate. Don’t forget to press the lock

button on your keyfob to re-lock the

vehicle.

Charging

Note: The vehicle must be in P (Park) to

charge.

To charge your high-voltage battery:

1. Put the vehicle in P (Park) and power

down the vehicle.

2. Press the indentation located on the

charge port door and the door will

rotate open.

3. Plug the charging coupler into the

vehicles charge port receptacle and

make sure the button clicks confirming

that it is completely engaged.

E144780

4. Verify that the cord acknowledgment

feature activates. This indicates the

beginning of a normal charge cycle.

5. If using a 240–volt charging station,

follow the instructions on the charge

station to begin the charging process.

When charging, the light ring will display

how far along the charge is:

• When the top right quadrant is pulsing

the charge is between 0-25 percent.

• When the top right quadrant is solidly

lit and the bottom right quadrant is

pulsing the charge is between 25-50

percent.

• When both right side quadrants are

solidly lit and the bottom left quadrant

is pulsing the charge is between 50-75

percent.

• When three quadrants are solidly lit

and the top left quadrant is pulsing the

charge is between 75-100 percent.

• When the entire ring is solidly lit, the

charge is complete.

Note: The illuminated ring will shut off one

minute after reaching a full charge.

Note: If a vehicle charging system fault is

detected at any point in a charge cycle the

entire light ring will flash continuously for

one minute and then shut off. If this

happens unplug, and then re-plug the

charging coupler into the charge port

receptacle. If the problem persists contact

your authorized dealer if a charge fault is

detected.

Disconnecting the Charging Coupler

Note: Do not pull the wall plug from the

wall while the vehicle is charging. Doing so

may damage the outlet and the cord.

1. Press the button on the charging

coupler.

2. While holding the button, remove the

charging coupler from the vehicle’s

charge port receptacle.

172

High Voltage Battery

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 460 461

Commentaires sur ces manuels

Pas de commentaire