Ford 2013 Fusion Hybrid v.1 Manuel d'utilisateur télécharger pdf (Page 173)

Note: Your electrical source must meet

certain requirements for the high-voltage

batteries to charge. The AC outlet must be

a three-prong 110-120 volt AC outlet that is

properly grounded, 15–20 amps (or greater),

and in good condition. The line also must

be dedicated, which means that no other

appliances should be connected to the

same circuit. If a dedicated circuit is not

used, the circuit breaker could trip or open.

If a dedicated circuit is not available, contact

a licensed professional electrician for proper

installation.

Make sure that the 120–volt convenience

cord is completely unwound before

charging. Always plug the cord into the AC

outlet before connecting the charging

coupler into the vehicle’s charge port

receptacle. The 120–volt convenience cord

inline control box has three indicator lights

that represent the charging status; power,

charge and fault.

Power (green light)— this indicator lights

up when the cord is plugged into the AC

wall outlet.

Charge (green light)— indicates status

of charging:

• No light means the cord is not

connected to the vehicle.

• Blinking light means that the charging

is in process.

• Solid light means that the vehicle is

connected but not charging.

Fault (red triangle light)— Lights up in

case of a detected failure. No charging is

possible:

• Blinking red triangle light – means that

the 120–volt convenience cord is trying

to reset the failure and could restart

the charging cycle.

• Solid red triangle light – means that

the fault is permanent. The cord needs

to be unplugged and re-plugged to

reset the fault. If the fault persists,

contact your authorized dealer.

Charge Port

The charge port is located between the

front left side door and front left wheel

well. There is an indentation located on

the charge port door that allows you to

press to open and press to close the door.

E144779

Note: Do not force the charge port door

open or closed. Forcing the door open or

closed will damage the charge port.

The light ring located around the charge

port indicates the charge status of your

batteries while connected to a charge

station or convenience cord. The charge

port light ring is divided into four quadrants

that inform you of the charge status.

There is a cord acknowledgment feature

that will be activated when a charge cycle

is initiated. The four light quadrants will

each individually flash clockwise starting

with the top right light and ending with the

top left, two full times confirming a

charging coupler has been detected.

171

High Voltage Battery

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 460 461

Commentaires sur ces manuels

Pas de commentaire