Ford 2012 F-150 Raptor v.1 Manuel d'utilisateur télécharger pdf (Page 379)

100

101

5. Locate and carefully remove the

engine oil level dipstick. See

Identifying components in the

engine compartment in this

chapter for location of dipstick.

6. Wipe the dipstick clean. Insert the dipstick fully, then remove it again.

• If the oil level is between the lower and upper holes or between

the MIN and MAX marks (depending on application), the oil

level is acceptable. DO NOT ADD OIL.

• If the oil level is below the lower hole or the MIN mark, add enough

oil to raise the level within the lower and upper holes or within the

MIN-MAX range.

• Oil levels above the upper hole or the MAX mark may cause engine

damage. Some oil must be removed from the engine by an authorized

dealer.

7. Put the dipstick back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

normal operating range on the engine oil level dipstick.

4. Install the dipstick and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

1/4 of a turn until three clicks are heard or until the cap is fully seated.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level dipstick and/or the engine oil filler cap removed.

Maintenance and Specifications

379

2012 F-150 (f12)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 374 375 376 377 378 379 380 381 382 383 384 ... 461 462

Commentaires sur ces manuels

Pas de commentaire

Ford 2012 F-150 Raptor v.1 Manuel d'utilisateur Page 379

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2012 F-150 Raptor v.1