Ford 2012 F-150 Raptor v.1 Manuel d'utilisateur télécharger pdf (Page 254)

6. Remove the valve cap from the valve stem on the left front tire;

decrease the air pressure until the horn sounds.

Note: The single horn chirp confirms that the sensor identification code

has been learned by the module for this position. If a double horn is

heard, the reset procedure was unsuccessful, and must be repeated.

7. Remove the valve cap from the valve stem on the right front tire;

decrease the air pressure until the horn sounds.

8. Remove the valve cap from the valve stem on the right rear tire;

decrease the air pressure until the horn sounds.

9. Remove the valve cap from the valve stem on the left rear tire;

decrease the air pressure until the horn sounds.

Training is complete after the horn sounds for the last tire trained

(driver’s side rear tire), the TPMS indicator stops flashing, and the

message center (if equipped) displays:

TRAINING COMPLETE.

10. Turn the ignition off. If two short horn beeps are heard, the reset

procedure was unsuccessful and must be repeated.

If after repeating the procedure and two short beeps are heard when the

ignition is turned to off, seek assistance from your authorized dealer.

11. Set all four tires to the recommended air pressure as indicated on

the Safety Compliance Certification Label or Tire Label located on the

B-Pillar or the edge of the driver’s door. See Vehicle loading - with and

without a trailer in this chapter for more information.

SNOW TIRES AND CHAINS

WARNING: Snow tires must be the same size, load index, speed

rating as those originally provided by Ford. Use of any tire or

wheel not recommended by Ford can affect the safety and performance

of your vehicle, which could result in an increased risk of loss of vehicle

control, vehicle rollover, personal injury and death. Additionally, the use

of non-recommended tires and wheels could cause steering, suspension,

axle or transfer case/power transfer unit failure.

The tires on your vehicle have all-weather treads to provide traction in

rain and snow. However, in some climates, you may need to use snow

tires and chains. If you need to use chains, it is recommended that steel

wheels (of the same size and specifications) be used, as chains may chip

aluminum wheels.

Tires, Wheels and Loading

254

2012 F-150 (f12)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 461 462

Ford 2012 F-150 Raptor v.1 Manuel d'utilisateur Page 254