Ford 2012 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 217)

The LATCH anchors for child seat

installation are located at the rear

section of the rear seat between the

cushion and seat back, below the

locator symbols on the seatback.

Follow the child seat manufacturer’s

instructions to properly install a

child seat with LATCH attachments.

Follow the instructions on attaching child safety seats with tether straps.

Refer to Attaching child safety seats with tether straps later in this

chapter.

Attach LATCH lower attachments of the child seat only to the anchors

shown.

WARNING: Never attach two child safety seats to the same

anchor. In a crash, one anchor may not be strong enough to hold

two child safety seat attachments and may break, causing serious

injury or death.

WARNING: Depending on where you secure a child restraint,

and depending on the child restraint design, you may block

access to certain safety belt buckle assemblies and/or LATCH lower

anchors, rendering those features potentially unusable. To avoid risk of

injury, occupants should only use seating positions where they are able

to be properly restrained.

Use of inboard lower anchors from the outboard seating positions

(center seating use)

The lower anchors at the center of the second row bench seat are

spaced 520 mm (20.5 inches) apart. The standardized spacing for LATCH

lower anchors is 280 mm (11 inches) center to center. A child seat with

rigid LATCH attachments cannot be installed at the center seating

position. LATCH compatible child seats (with attachments on belt

webbing) can only be used at this seating position provided that the

child seat manufacturer’s instructions permit use with the anchor spacing

stated. Do not attach a child seat to any lower anchor if an adjacent

child seat is attached to that anchor.

Seating and Safety Restraints

217

2012 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 437 438

Pas de commentaire

Ford 2012 Explorer v.2 Manuel d'utilisateur Page 217