Ford 2009 Taurus X v.1 Manuel d'utilisateur télécharger pdf (Page 117)

Erasing HomeLink姞 buttons

To erase the three programmed

buttons (individual buttons cannot

be erased):

• Press and hold the two outer

HomeLink威 buttons until the

indicator light begins to

flash-after 20 seconds. Release

both buttons. Do not hold for

longer that 30 seconds.

HomeLink威 is now in the train (or learning) mode and can be

programmed at any time beginning with Step 1 in the Programming

section.

Reprogramming a single HomeLink姞 button

To program a device to HomeLink威 using a HomeLink威 button previously

trained, follow these steps:

1. Press and hold the desired HomeLink威 button. Do NOT release the

button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the HomeLink威 button, follow Step 1 in the Programming

section.

For questions or comments, contact HomeLink威 at www.homelink.com

or 1–800–355–3515.

MESSAGE CENTER

With the ignition on, the message

center, located on your instrument

cluster, displays important vehicle

information through a constant

monitor of vehicle systems. You

may select display features on the

message center for a display of status. The system will also notify you of

potential vehicle problems with a display of system warnings followed by

a long indicator chime.

Selectable features

Reset

Press this control to select and reset functions shown in the INFO menu

and SETUP menu.

2009 Taurus X (219)

Owners Guide, 1st Printing

USA (fus)

Driver Controls

117

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 359 360

Pas de commentaire

Ford 2009 Taurus X v.1 Manuel d'utilisateur Page 117