Ford 2009 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 83)

• 2–door SuperCab

To lower the shoulder belt height, push the button and slide the height

adjuster down. To raise the height of the shoulder belt, push the button

and slide the height adjuster up. Pull down on the height adjuster to

make sure it is locked in place.

WARNING: Position the safety belt height adjusters so that the

belt rests across the middle of your shoulder. Failure to adjust

the safety belt properly could reduce the effectiveness of the seat belt

and increase the risk of injury in a collision.

Safety belt extension assembly

If the safety belt is too short when fully extended, there is an 8 inch

(20 cm) safety belt extension assembly that can be added (part number

611C22). This assembly can be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

WARNING: Do not use extensions to change the fit of the

shoulder belt across the torso.

Safety belt warning light and indicator chime

The safety belt warning light illuminates in the instrument cluster and a

chime sounds to remind the occupants to fasten their safety belts.

2009 Ranger (ran)

Owners Guide, 2nd Printing

USA (fus)

Seating and Safety Restraints

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 273 274

Pas de commentaire

Ford 2009 Ranger v.2 Manuel d'utilisateur Page 83