Ford 2009 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 164)

Programming a personal entry code and keypad association to

memory seats, mirrors and pedals

To create your own personal entry code:

1. Enter the factory set code.

2. Within five seconds press the 1 • 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered

within five seconds of each other.

4. To associate the entry code with a memory setting, enter a sixth digit

to indicate which driver should be set in a memory recalled by the

personal entry code:

• Pressing 1 • 2 recalls Driver 1 settings.

• Pressing 3 • 4 recalls Driver 2 settings.

• Pressing other keypad buttons or not pressing a keypad button as a

sixth digit does not set a driver and will not recall a memory setting.

Note: The factory-set code cannot be associated with a memory

setting.

5. The doors will again lock then unlock to confirm that your personal

keycode has been programmed to the module.

Tips:

• Do not set a code that uses five of the same number.

• Do not use five numbers in sequential order.

• The factory set code will work even if you have set your own personal

code.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Within five seconds, press the 1 • 2 on the keypad and release.

3. Press and hold the 1 • 2 for two seconds. This must be done within

five seconds of completing Step 2.

Your personal code is now erased and only the factory set 5–digit code

will work.

Anti-scan feature

If an incorrect code has been entered seven times (35 consecutive

button presses), the keypad will go into an anti-scan mode. This mode

disables the keypad for one minute and the keypad lamp will flash during

this time.

2009 F-250/350/450/550 (f23)

Owners Guide, 1st Printing

USA (fus)

Locks and Security

164

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 417 418

Pas de commentaire

Ford 2009 F-550 v.1 Manuel d'utilisateur Page 164