Ford 2009 F-150 v.2 Manuel d'utilisateur télécharger pdf (Page 168)

Before you can reach and latch a combination lap and shoulder belt

having a cinch tongue into the buckle, you may have to lengthen the lap

belt portion of it.

1. To lengthen the lap belt, pull

some webbing out of the shoulder

belt retractor.

2. While holding the webbing below

the tongue, grasp the tip (metal

portion) of the tongue so that it is

parallel to the webbing and slide the

tongue upward.

3. Provide enough lap belt length so that the tongue can reach the

buckle.

How to fasten the cinch tongue (Regular Cab center only)

1. Pull the combination lap and shoulder belt from the retractor so that

the shoulder belt portion of the safety belt crosses your shoulder and

chest.

2. Be sure the belt is not twisted. If the belt is twisted, remove the twist.

3. Insert the belt tongue into the proper buckle for your seating position

until you hear a snap and feel it latch.

4. Make sure the tongue is securely fastened to the buckle by pulling on

the tongue.

WARNING: The lap belt should fit snugly and as low as possible

around the hips, not across the waist.

WARNING: Front and rear seat occupants, including pregnant

women, should wear safety belts for optimum protection in an

accident.

WARNING: Each seating position in your vehicle has a specific

safety belt assembly which is made up of one buckle and one

tongue that are designed to be used as a pair. 1) Use the shoulder belt

on the outside shoulder only. Never wear the shoulder belt under the

arm. 2) Never swing the safety belt around your neck over the inside

shoulder. 3) Never use a single belt for more than one person.

2009 F-150 (f12)

Owners Guide, 2nd Printing

USA (fus)

Seating and Safety Restraints

168

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 408 409

Pas de commentaire

Ford 2009 F-150 v.2 Manuel d'utilisateur Page 168