Ford 2008 Crown Victoria Manuel d'utilisateur télécharger pdf (Page 38)

HEADLAMP CONTROL

Turns the lamps off.

Turns on the parking

lamps, instrument panel lamps,

license plate lamps and tail lamps.

Turns the headlamps on.

Autolamp control

The autolamp system provides light

sensitive automatic on-off control of

the exterior lights normally

controlled by the headlamp control.

The autolamp system also keeps the

lights on for a predetermined period

of time after the ignition switch is

turned to OFF. The delay period can

be adjusted up to a maximum of

approximately 3 minutes in

duration.

• To turn autolamps on, rotate the control counterclockwise to the next

position from OFF.

• To turn autolamps off, rotate the control clockwise

The headlamps will also turn on when the wipers are turned on.

To change the duration of the autolamp delay, carry out the following

sequence:

Note: Steps 2 through 5 must be carried out within a 10 second period.

1. Start with the ignition switch in the OFF position and the headlamp

switch in the AUTOLAMP position.

2. Place the headlamp switch in the OFF position.

3. Place the ignition switch in the RUN position and then back to OFF.

4. Place the headlamp switch in the AUTOLAMP position.

• At this point, the exterior lamps turn on.

2008 Crown Victoria (cro)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 279 280

Pas de commentaire

Ford 2008 Crown Victoria Manuel d'utilisateur Page 38