Ford 2007 F-150 v.3 Manuel d'utilisateur Page 289

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 376
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 288
11. Remove the jack and fully
tighten the lug nuts in the order
shown (Refer to Wheel lug nut
torque specifications later in this
chapter for the proper lug nut
torque specification):
Six lug nut wheel
Seven lug nut wheel
12. Stow the flat tire. Refer to Stowing the flat/spare tire.
13. Stow the jack and lug wrench. Make sure the jack is fastened so it
does not rattle when you drive.
14. Unblock the wheels.
Stowing the flat/spare tire
Note: Failure to follow spare tire stowage instructions may result in
failure of cable or loss of spare tire.
1. Lay the tire on the ground with the valve stem facing in the direction
specified on the Tire Changing Instructions located with the jack
hardware.
2. Slide the wheel partially under the vehicle and install the retainer
through the wheel center. Pull on the cable to align the components at
the end of the cable.
3. Turn the jack handle clockwise until the tire is raised to its stowed
position underneath the vehicle. The effort to turn the jack handle
increases significantly and the spare tire carrier ratchets or slips when
the tire is raised to the maximum tightness. Tighten to the best of your
ability, to the point where the ratchet/slip occurs, if possible. The spare
tire carrier will not allow you to overtighten. If the spare tire carrier
2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Roadside Emergencies
289
Vue de la page 288
1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 375 376

Commentaires sur ces manuels

Pas de commentaire