Ford 2007 Expedition v.1 Manuel d'utilisateur télécharger pdf (Page 223)

Do not drive your vehicle until you verify that the brakelamps

are working.

Always set the parking brake fully and make sure the gearshift is

latched in P (Park). Turn the ignition to the LOCK position and

remove the key whenever you leave your vehicle.

If the parking brake is fully released, but the brake warning lamp

remains illuminated, the brakes may not be working properly.

See your authorized dealer.

Brake-shift interlock – floor-shift transmission

This vehicle is equipped with a brake-shift interlock feature that prevents

the gearshift lever from being moved from P (Park) when the ignition is

in the ON position unless the brake pedal is depressed.

If you cannot move the gearshift lever out of P (Park) with ignition in

the ON position and the brake pedal depressed, or when the ignition is

in the OFF position, it is possible that a fuse has blown or the vehicle’s

brakelamps are not operating properly. Refer to Fuses and relays in the

Roadside Emergencies chapter.

If the fuse is not blown, perform the following procedure:

1. Apply the parking brake, turn the ignition to OFF, then remove the key.

2. Using a screwdriver or similar

tool, remove the protective cover to

the interlock release access hole,

located to the right of the gearshift

lever.

3. Insert a screwdriver or similar

tool straight down into the access

hole and press downward while

pulling the gearshift lever out of the

P (Park) position and into the N

(Neutral) position.

4. Remove tool and reinstall the protective cover.

2007 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Driving

223

1 2 ... 218 219 220 221 222 223 224 225 226 227 228 ... 327 328

Pas de commentaire

Ford 2007 Expedition v.1 Manuel d'utilisateur Page 223