Ford 2007 E-450 v.1 Manuel d'utilisateur télécharger pdf (Page 59)

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of four)

available before beginning this procedure. If all remote entry transmitters

are not present during programming procedure, the ones missing during

programming will no longer operate the vehicle.

Note: Ensure the brake pedal is not

depressed during this sequence.

To reprogram the remote entry

transmitters:

1. Ensure the vehicle is

electronically unlocked.

2. Place the key in the ignition and turn

from the (2) LOCK position to (3) OFF.

3. Cycle eight times rapidly (within 10 seconds) between the (3) OFF

position and (4) ON. Note: The eighth turn must end in the (4) ON

position.

4. The doors will lock, then unlock, to confirm that the programming

mode has been activated.

5. Within 20 seconds press any button on the remote entry transmitter.

Note: If more than 20 seconds have passed you will need to start the

procedure over again.

6. The doors will lock, then unlock, to confirm that this remote entry

transmitter has been programmed.

7. Repeat Steps 4 and 5 to program each additional remote entry

transmitter (up to four transmitters).

8. Turn the ignition to the (3) OFF position after you have finished

programming all of the remote entry transmitters.

9. The doors will lock, then unlock, to confirm that the programming

mode has been exited.

Illuminated entry

The interior lamps illuminate when the remote entry system is used to

unlock the door(s) or sound the personal alarm.

The illuminated entry system will turn off the interior lights if:

• the ignition switch is turned to the 4 (ON) or 1 (ACCESSORY)

position, or

• the remote transmitter lock control is pressed, or

• after 25 seconds of illumination.

2007 Econoline (eco)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 263 264

Pas de commentaire

Ford 2007 E-450 v.1 Manuel d'utilisateur Page 59