Ford 2014 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 125)

In-vehicle Programming

This process is to program your hand-held

transmitter and your in-vehicle HomeLink

button.

Note: Put a new battery in the hand-held

transmitter. This will ensure quicker training

and accurate transmission of the

radio-frequency signal.

E142658

1. With your vehicle parked outside of the

garage, turn your ignition to the on

position, but do not start your vehicle.

2. Hold your hand-held garage door

transmitter 1–3 inches (2–8

centimeters) away from the HomeLink

button that you want to program.

3. Using both hands, simultaneously,

press and hold the desired HomeLink

button and the hand-held transmitter

button. DO NOT release either one until

the HomeLink indicator light flashes

slowly and then rapidly. When the

indicator light flashes rapidly, you can

release both buttons. The rapid

flashing indicates successful training.

4. Press and hold the HomeLink button

you programmed for five seconds, then

release. You may need to do this twice

to activate the door. If your garage door

does not operate, watch the HomeLink

indicator light.

If the indicator light stays on, the

programming is complete. See

Programming Your Garage Door Motor

later in this section.

If the indicator light flashes rapidly for two

seconds and then turns to a constant light,

you have not programmed the HomeLink

button yet. Do the following:

Press and hold the HomeLink button while

you press and release the hand-held

transmitter button every two seconds. The

HomeLink indicator light will flash slowly

and then rapidly once the HomeLink

function button recognizes and accepts

the hand-held transmitter’s radio

frequency signal.

After programming the HomeLink button,

begin programming your garage door

opener motor.

Note: You may need a ladder to reach the

unit and you may need to remove the cover

or lamp lens on your garage door opener.

E142659

To program additional buttons, repeat

Steps 1 – 4.

For questions or comments, please contact

HomeLink at www.homelink.com or

1-800-355-3515.

Programming Your Garage Door

Opener Motor

1. Press the learn button on the garage

door opener motor and then you have

30 seconds to complete the next two

steps.

2. Return to your vehicle.

122

Super Duty (TFA)

Universal Garage Door Opener

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 457 458

Commentaires sur ces manuels

Pas de commentaire