Ford 2013 Flex v.1 Manuel d'utilisateur télécharger pdf (Page 219)

100

101

Do not drive your AWD vehicle in deep sand for an extended period of

time. This will cause the AWD system to overheat. After the system has

cooled down, normal AWD function will return. When driving at slow

speeds in deep sand under high outside temperatures, use L (Low) gear

when possible. L (Low) gear operation will maximize the engine and

transmission cooling capability.

Under severe operating conditions, the A/C may cycle on and off to

protect overheating of the engine.

Avoid excessive speed because vehicle momentum can work against you

and cause the vehicle to become stuck to the point that assistance may

be required from another vehicle. Remember, you may be able to back

out the way you came if you proceed with caution.

Mud and Water

If you must drive through high water, drive slowly. Traction or brake

capability may be limited.

When driving through water, determine the depth; avoid water higher

than the bottom of the wheel rims (for cars) or the bottom of the hubs

(for trucks) (if possible) and proceed slowly. If the ignition system gets

wet, the vehicle may stall.

Once through water, always try the brakes. Wet brakes do not stop the

vehicle as effectively as dry brakes. Drying can be improved by moving

your vehicle slowly while applying light pressure on the brake pedal.

Be cautious of sudden changes in vehicle speed or direction when you

are driving in mud. Even AWD vehicles can lose traction in slick mud. As

when you are driving over sand, apply the accelerator slowly and avoid

spinning your wheels. If the vehicle does slide, steer in the direction of

the slide until you regain control of the vehicle.

After driving through mud, clean off residue stuck to rotating driveshafts

and tires. Excess mud stuck on tires and rotating driveshafts causes an

imbalance that could damage drive components.

Note: Driving through deep water may damage the transmission.

If the front or rear axle is submerged in water, the axle lubricant and

PTU (power transfer unit) lubricant should be checked and changed if

necessary.

All-Wheel Drive 219

2013 Flex (471)

Owners Guide gf, 1st Printing

USA (fus)

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 557 558

Commentaires sur ces manuels

Pas de commentaire

Ford 2013 Flex v.1 Manuel d'utilisateur Page 219

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2013 Flex v.1